If you need to add multiple marks you can add them as needed providing you figure the X and Y coordinates out, which if you work off center is pretty easy. You can control the length of them, which would be the height measurement or width measurement depending on if its a vertical or horizontal mark you are adding. I am looking to knock out some areas for diecutting purposes. I am having an issue with the marks on the sheet, being knocked out by page bleed. Then Reimporting this whole sheet back into PREPS as one big mark. Is to create a template with the page numbers that dont correspond (however positioning the marks on the pages that I want). If not, the only way I see that I can go forward with the marks that I want. I need to know if it is possible to remove an individual mark.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |